56
ENGLISH
[1] Apply a multimeter to measure whether the
voltage of variable voltage rectifier is in the range of
“
13V
～
14.0V
”
. If it is lower than
“
13V
”
, it is
necessary to install a new .variable voltage rectifier.
If the heat sink of the variable voltage rectifier is
damaged, it is necessary to install a new .variable
voltage rectifier.
2. Demolition and Maintenance of the Control Portion
Caution
[2] Remove the flasher socket of the signal system
and apply a multimeter to measure whether the
flasher is short-circuited. If the flasher is short-
circuited, it is necessary to replace it.
[3] Check whether the starting relay is working
properly. If the star ting relay does not work
properly, it is necessary to install a new starting
relay of the same model.
[4] Remove the RHS and LHS combination control
button switch and check whether these control
button switches are short-circuited or damaged.
Repair or replace such switches if necessary.
Check whether the front and rear brake lamp
switches are working properly. If the brake lamp
switches cannot work properly, it is necessary to
re-adjust and replace them.
If the front and rear brake lamps do not light
during braking, it indicates there is no electrical
start.
Caution
Variable voltage
rectifier connector
Flasher
Starting relay
Control switch
