4
2.1.2 The Rear Panel
The rear panel contains the following features. (Viewed from left to right)
1.
Power Jack only use the power adapter applied with ZEW3002 to prevent damage
2.
One LAN 10/100Mbps RJ45 port for connecting to the router/modem, local PC or
switch/hub.
3.
Factory Default Reset button
4.
One external dipole antenna
There is a way to reset the ZEW3002’s factory defaults by using the Factory Default
Reset button:
1.
Turn on ZEW3002’s power
2.
Press and hold the default reset button, until the system LED lights up (about 5
seconds)
3.
Release the reset button and wait for ZEW3002 to reboot.
Note: Ensure ZEW3002 is powered on before it restarts completely.
2.2 System Requirements
Broadband Internet Access Service (DSL/Cable/Ethernet)
PC on the LAN needs a working Ethernet Adapter and an Ethernet cable with RJ45
connector
TCP/IP protocol must be installed on each PC
Web browser, such as Microsoft Internet Explorer 5.5 or later, Netscape Navigator 6.1
or later
2.3 Installation Environment Requirements
Do not in direct sunlight or near a heater or heating vent
Do not in cluttered or crowded place. There should be at least 2 inches (5 cm) of clear
space on all sides of ZEW3002
Well ventilated (especially if it is in a closet)
Operating temperature: 0°C~40°C
Operating Humidity: 10%~95%RH, Non-condensing
All manuals and user guides at all-guides.com
all-guides.com
