©2017 ZONEFIRST® | 6 Aspen Drive
–
Randolph, NJ. 07869-1103 | Telephone: 201-794-8004 | Fax: 201-794-1359
www.zonefirst.com
|
Controlling Your Comfort Room by Room
The ZD series are extruded aluminum parallel blade dampers
compete with a Power Open Power Close Plug-In Motor. These
dampers are shipped complete and ready for installation. The
lightweight ZD can be installed in any position in any properly sized
duct. These dampers are rated for duct pressure up to
2.
0”
W.C.
Dampers are available all in even sizes from 8
”
x8
”
to 3
6”
x24
”
. All
dampers are
1/4” un
dersized from their listed size. Dampers are
ordered as ZDSP for side mount, width by height, as the motor
and end plate will be on the smaller dimension, for typical insertion
into the side/shorter dimension of the duct. The ZDBP denotes
bottom mount and is ordered height by width. The motor and
end plate are on the longer dimension for typical insertion into
either the bottom or top of the duct. Dampers are ordered as
ZDSPwwhh or ZDBPhhww, using 2 digits for each dimension. All ZD
dampers are shipped in the Open position ready for installation.
A 12 Volt DC damper motor, Model MP12M, powers the damper
closed and open. The MP12M motor wires by simply plugging
the motor in using the modular cord, supplied with each
damper.
The modular cord is a 25’ length of standard four (4)
conductor telephone wire with RJ11 jacks on each end. The
motor is complete with 2 jacks allowing you to daisy chain up to
10 dampers per zone.
The MP12M motor has been tested to over 1,000,000 cycles to
provide long life. Even replacing the motor is a simple less than
one (1) minute change by loosening the setscrew holding the
motor onto the damper, slide the motor off the damper shaft,
place a new one on and secure with the screw.
The MP12M motor also has a two-color Light Emitting Diode (LED)
to indicate the damper position. When the LED is
GREEN
the
damper is
Open
. When the LED is
RED
the damper is
Closed
.
When the LED is not lit the motor is typically moving between open
and closed. The motor cycles between open and closed in less
than 5 seconds
Actuator & 25
’ of
modular cord included with each damper
Minimum Position
Adjustment
Simply open the cover to
minimum position setting.
With a screwdriver, loosen
the setscrew and adjust
your setting to desired
position.
ZONE DAMPER
With MP12M Plug-In Motor
Model: ZDSP & ZDBP
ZDSP Side Mount
ZDBP-Bottom Mount
Dimensional Drawing
(nominal)
Damper Specifications
Construction
–
Aluminum Mill Finish, Mitre Angles
Linkage
–
Zinc plated linkage arms, Delrin bushings
Dimensions
–
8”x8”
to
36”x24”
in
2”
increments, 1/
4”
undersized.
Custom sizes also available
Motor Voltage
–
12VDC, 0.100A
Torque
–
7.0 in/lbs, 112.0 in/oz, 0.79NM
Temperature Rating - 0 F to 150 F Operating, -13 F to 150 F Storage
Humidity
–
5% to 95% Non-Condensing
Damper Timing
–
Nominal 5 Sec. Powered Open-Closed \
Connection - Modular RJ11, 2 Ports
Duct Pressure
–
Maximum
2”W.C.
