Page 14
The ZonarSound System
Installation Manual
Issue 01
5.2 Setting the Sound Level
Power
Audio
Output
Fault
Volume
Once the audio source has been connected and the DCLA 100 has been powered, the
volume control located on the front of the DCLA 100 sets the volume for all Slave panels.
To ensure that all panels produce the same
Volume,the switched volume control, located on
the upper face of each Slave panel, should be
set to 0dB.
The volume of an individual Slave panel can be
set lower than the amplifier output by adjusting
its switched volume control. The Slave panel
can never be louder than the volume set on the
master volume control.
5.3 Indicators
The LED indicators on the front of the Amplifier box are as follows:
Name
Colour
Function
Audio
Blue
Flashes in sync with the incoming audio.
Increases in overall brightness with higher audio levels.
Will not be illuminated whenever OUTPUT FAULT LED is illuminated.
Output
Fault
Red
Will illuminate whenever a fault (short circuit) is detected at the HV
output.
Illuminates for approx. 10 seconds and will then go out.
If the fault persists, the LED will illuminate again and the cycle will be
repeated until the fault is removed.
Power
Green
Illuminated when power is supplied to the unit and switched ON.
www.zonarsound.com
VOLUME
-15dB
-6
d
B
-9
d
B
-12
dB
-3
d
B
0d
B
