Zonar Connect
®
Installation/User Guide
Mounting & Operation
Mounting position considerations:
1) Verify placement acceptability with state DOT/Law Enforcement prior to installation.
2) Follow all general guidelines on page 12.
Do:
1) Mount in the vehicle at a convenient height and angle for drivers and co-drivers to access.
2) Ensure location of the installed Zonar Connect does not block driver view (including mirrors and gauges)
or
interfere with vehicle safe operation of the vehicle’s controls.
3) Ensure that the placement of the Zonar Connect allows drivers/co-drivers to easily dock and undock
the tablet.
4) Ensure mounting surface is strong enough to support RAM mount and the Zonar Connect.
5) Choose a location which does not impede driver/co-driver entry
6) Choose a location which is within easy reach of driver / co-driver, and within normal line-of-sight.
7. Lay all components out prior to installation to check for cable length and interference issues.
Don’t:
1) Do not mount the Zonar Connect in an area that may interfere with the deployment of an air bag.
2) Do not install the Zonar Connect in a location that may impact the driver /co-driver in the event of an
accident or sudden stop.
3) Do not mount the Zonar Connect in dirty or wet areas.
4) Do not mount the Zonar Connect in areas of direct sunlight
5) Do not install the Zonar Connect in front of an open AC or heater vent. If unable to install elsewhere,
close the louvered vent the Zonar Connect is installed in front of.
6) Do not install the Zonar Connect near windows and vents which may pass rain water.
7) Avoid mounting the Zonar Connect in an area that may limit leg room or where the Zonar Connect may
likely be used as foot, elbow, etc. rest.
Mounting Installation
Refer to mounting locations guide (see Fig. 15-1) for examples of ideal mounting locations. Mounting
locations may vary based on the type of vehicle or driver requirements.
1) Attach RAM mount to a location visible and accessible to the driver.
2) Use backing plate to secure mount.
