Zonair3D AIR PRO 1200, Руководство пользователя

Страница: 18 / 30

5.6.2 CONNECTION PANEL DIAGRAM
5.6.2.1 ELECTRICAL AND CONTROL WIRING CONNECTION DETAIL
IMPORTANT: If the customer has NOT opted to purchase the probe, they do NOT
have to touch ANYTHING on the terminal block that comes from the factory,
that is, cables 18 and 20 have to go together (bridge mode). If the client HAS
purchased the probe, they must separate cables 18 and 20 from the terminal strip
for the correct operation of the equipment, in this way the probe will govern the
equipment based on the air quality.
5.6.2.2 NOTICE DETAIL OF FILTER STATUS
The equipment has an integrated system (regardless of the probe) of leds that
indicates the status of the filters, when the leds are off, the status of the filters
is correct, when the leds turn red, it indicates that the filter must be changed. led
filter on.
IMPORTANT NOTE: When changing the GRSystem filter (GRSV gas filter) you
have to access the inside of the Electronic Control Board (PCB) (see situation in
point 5.2.2.1) by unscrewing the front plastic cover and carry out the following
action, press button P1 RESET CARBON/COAL continuously until the red alarm
led is deactivated.
THE LIGHT ABOVE SHOW THAT THE INDICATED
FILTER IS OVERFILLED. IN THAT CASE, FOR
THE CORRECT WORK OF THE SYSTEM, PLEASE
CONTACT YOUR DISTRIBUTOR TO REPLACE THEM.
GRSV F7 G4 H14
FILTER
SUBSTITUTION
B
A
C
(A) Black cable = 230V power supply
(B) Upper gray cable = planned connection to the Z3D air quality sensorN
for filter review notice, there are 2 cables marked with numbers 5 and 6 that
correspond to the numbers where they have to be connected inside said probe.
(C) Lower gray cable = provision for connection to the Z3D air quality probe for
purifier ON/OFF control based on indoor air quality limits, there are 2 cables
marked with the numbers 18 and 20 that correspond to the numbers where
they have to be connected inside said probe.
See diagrams point 5.8.1.