•
Before fully tightening bolts, align the rack visually to remove any twist and by
measuring across the diagonals as shown. This will make the rails and modules easier
to install.
•
With rack aligned, tighten bolts.
* - Some rack configurations come with a
Protector Angle. This is a long section of
steel angle that spans between both
canisters and protects the copper tube
when rail length is insufficient to do so. If
this is provided with your rack, install it
now.
Extruded Mounting Rail Installation
•
Description: The Zomeworks Extruded Rail is
designed to be mounted to the sliders using 3/8”
round-head, square-neck bolts. The edges of the
extrusion are different – one side has a slot to
accommodate standard 1/4” hex bolts and the other
*5/16” hex bolts (see diagram at right). When
installing rails on to the Truss Tube pay attention to
this orientation!
*- Zomeworks only provides 1/4” hardware for modules. For specific modules, 5/16”
hardware can be supplied by the customer / installer.
•
In order to mount the Extruded Rails in the correct spot, use a permanent marker to
layout the position of the Rail Sliders. This can be done a couple of ways:
Method 1: Find the center of the Extruded Rail. Mark lines the “Half Distance” away on
both sides of center. Refer to the table below to find the correct distance. These marks
will coincide with the centerline spacing of the Truss Tubes.
