•
Tighten jam nut firmly.
•
The 25-pound weight should be installed at a point approximately 1/2 the way down
the Unistrut®. Fine adjustments are best made after monitoring the performance of the
rack.
•
See diagram (above) for placement of hardware.
Installing Shadow Plates
•
Two Shadow Plates are provided with the
UTRF-072. The plate that has a
Zomeworks sticker is designed to be
installed on the NE corner of the rack.
•
Install the Shadow Plates so that the ends
of the plates are even with the ends of the
Canisters.
•
Using the 1/4” round-head screws, lock
washers, and wide flat washers provided,
install as shown.
Installing Storm Collar
•
The Storm Collar offers
additional protection from
high wind / storm events and
can also be used when
building or maintaining the
rack. The collar is an anchor
point for running ropes or
ratchet straps (to be
provided by the customer)
from the four corners of the
rack.
•
The installation height of the
Storm Collar is not critical –
we recommend 24” to 36”
above the ground level.
Balancing and Counterweight Adjustments
•
Balancing and set-up is crucial to getting the most out of your Track Rack™.
•
Start by ensuring that the module rails are installed equidistant from the center axle.
