Zoin Danny DC120BSVB171VA, Технические инструкции

Страница: 17 / 64

17
During the maintenance and cleaning pay attention
not to bend or damage the fins and the whole refri-
gerating unit.
Never neglect this operation, as it is basic for the good
working of the unit and to avoid possible breakings. When
you have finished this operation, fit the cover grid in its
original position.
When the cleaning operation is over, make sure that
everything is clean and dry before connecting the equi-
pment to the power supply again. When the unit reaches
the correct working temperature, it is possible to reload it.
In case of long absences (i.e. holidays etc.) the unit has
to be unplugged, emptied completely, cleaned and dried
to prevent bad smells.
A correct maintenance of the equipment can considerably
prolong its life.
19. TECHNICAL ASSISTANCE - servicing
If the equipment does not run properly or does not
work at all, in your own interest before calling for
servicing, we suggest to check the following points:
- if the plug is well inserted in the socket;
- if the power reaches the socket to which the equip-
ment is connected;
- if the thermostat is set as recommended;
- if the network voltage is the same as requested for
the equipment (+-6%);
- if the evaporator is covered with ice (in this case
proceed as indicated at paragraph 16);
- if the condenser is clean (paragraph 18);
- if there are air draughts, if the cabinet is installed
in the correct position (see paragraph 9) and if the
ambient temperature is as indicated (see paragraph
7).
20. REPLACEMENT OF LED CEILING LAMP
The replacement and the substitution of led ceiling lamp
must be made by qualified technician and when the unit
is disconnected from the power net.
Before replacing the ed ceiling lamp disconnect the
equipment by the general power supply. During the whole
replacement operation use proper working gloves.
21. NIGHT-BLIND
In case that the wall-cabinet is equipped with a night-blind,
we let you note that this night-blind is self-blocking, there
are no hooks to block it.
We suggest to always purchase the night-blind that should
be used during the closing time of the shop or in case
of suspension of the power supply (due to any cause).
The night-blind keeps the cold air inside the wall-cabinet
and so it helps to reduce the cold dispersion and to save
energy.
22. EMERGENCY SITUATIONS
Devices to be used in case of fire: powder-extinguishers
or liquid- extinguishers complying with the current legi-
slation.
23. DISMANTLING THE UNIT
The unit must be disposed of in accordance with
your country's waste management legislation.
IN CASE OF REQUEST FOR SERVICE, CONTROL
AND/OR REPLACEMENTS YOU WILL HAVE
TO CONTACT THE SUPPLIER WHERE THE CABI-
NET WAS BOUGHT.
24 . Attachments
1. EC declaration of conformity
2. Thermostat instructions.
3. Assembly instructions