3
© Copyright 2014 Zoeller Co. All rights reserved.
RECOMMENDED INSTALLATION
FOR ALL APPLICATIONS
PERFORMANCE DATA
INSTALLATION SKETCH
All installations must comply with all
applicable electrical and plumbing codes.
1. Electrical wiring and protection must be in accordance with governing
electrical codes.
2. All installations require a basin cover to prevent debris from falling into
the basin and to prevent injury.
3. Install proper Zoeller unicheck (combination union and check valve),
preferably just above the basin to allow easy removal of the pump
for cleaning or repair. If high head or below cover installation is
required, use 30-0163 on 1¼" pipe, 30-0164 on 1½" pipe, 30-0152
on 2" pipe and 30-0160 on 3" pipe.
4. When a unicheck is installed, drill a
3
/
16
" diameter hole in the discharge
pipe even with the top of the pump.
NOTE: THE HOLE MUST ALSO
BE BELOW THE BASIN COVER AND CLEANED PERIODICALLY.
Water stream will be visible from this hole when pump is operating.
5. Securely tape or clamp power cord to discharge pipe, clear of the float
mechanism(s).
6. Use a discharge pipe equivalent in diameter to the pump's discharge.
7. Basin must be in accordance with governing codes and
specifications.
8. Pump must be level and float mechanism(s) clear of sides of basin
before starting pump.
9. Basin must be clean and free of debris after installation.
10. Gate valve, shut-off valve, or ball valve to be supplied by installer and
installed according to any and all codes.
11. Locate float switches as shown in sketch below. The best place for
the
“off” point is above the motor housing and positioned 180° from the
inlet. Never put “off” point below discharge on pump
12. Gas-tight seals are required to contain gases and odors.
13. Vent gases and odors to the atmosphere through vent pipe.
14. Optional watertight control box available, see FM1597 for details.
15. For proper spacing of "On" - "Off" switches refer to local or
national standards and guildlines.
152954
TOT
AL
DYNAMIC HEAD
FLOW PER MINUTE
15
LITERS 0
GALLONS
20
40
5
10
0
2
5
25
100
80
60
20
50
TOTAL DYNAMIC HEAD/FLOW
PER MINUTE
SEWAGE
PUMP PERFORMANCE CURVE
MODEL 800
FEET
METERS
4
10
15
6
20
Shut-off Head:
15
4.6
Feet
Meters
5
10
1.5
3.0
MODEL
26 ft. (8.1m)
28
106
Gal.
Liters
46
38
174
144
800
45
40
35
30
25
30
35
120
140
160
180
8
10
20
6.1
18
68
25
7.6
4
19
SK3012
10cm (4") OF GRAVEL
GATE OR BALL VALVE
UNICHECK
FULLSIZE DISCHARGE PIPE
GAS TIGHT SEALS
VENT
BASIN LID
TAPE OR CLAMP
3/16" DIA. WEEP HOLE
SINGLE PIGGYBACK FLOAT
