3. Plug pump into a properly grounded 115V AC
power outlet.
RESET
RESET
TESTTEST
GFCI Outlet
3
OPERATION
1. Set pump on hard surface in water before starting.
Water must be a minimum of 1-3/4-in deep for pump
to operate.
The pump will run for 15 seconds after it is plugged in.
If water is being pumped during this 15 seconds, the
pump will continue operating until water level drops to
1/8-in. At that time, the pump will shut off .
After the pump shuts off , it will automatically turn
back on every three minutes for 15 seconds and then
turn back off if it is not pumping water. To re-start the
pump sooner, unplug the pump for a few seconds and
plug it back in.
NOTE: This pump does not contain a water level
sensor but will automatically shut itself off when water
level drops to 1/8-in. A built-in timer turns the pump
back on after 3 minutes and it will continue pumping
as long as water is present.
IL2059
1-3/4-in
minimum
to operate
1
5
2. To prevent unnecessary wear, unplug the pump from
the power output when not in use.
CAUTION: Extended usage of the pump in a partially
submerged or non-submerged situation may cause
the pump to overheat due to lack of heat dissipation
from the water. If this occurs, the pump will shut itself
off until the motor cools to its normal temperature.
Repeated overheating may cause damage to the
pump.
RESETRESET
TESTTEST
Unplug
Pump
Low Water
2
