HOSE ASSEMBLY
Step 1:
Lay hoses in a straight line in the sun for 1 hour to remove hose memory.
Step 2:
Measure the hose length from your return inlet to the farthest point in the pool. This is the
total length of Zippy
®
hose needed.
Step 3:
To assemble the hoses, connect the male end of the hose section into the female end. You
will hear a loud snap when they are connected properly. Each section should swivel easily.
NOTE:
If you need more hose, see your Zodiac dealer for additional sections.
Step 4:
Connect the 2 ft. hose section to the Wall Adapter and the Star Control
®
Assembly to the
opposite end of the 2 ft. hose section.
5’ Hose
Sections
Star Control Assembly
2' Hose Section
Wall Adapter
For a 2" Male Fitting
, remove both the male to male adapter and the threaded insert
from the Wall Adapter as shown in Figure 3A and thread the remainder of the Wall
Adapter onto the wall fitting as shown in Figure 3B.
FIGURE 3A
FIGURE 3B
5
NOTE:
If your pool has more than one return inlet, you must plug the inlet(s) not being used by Zippy
to insure sufficient flow rate. See your pool professional to purchase the appropriate parts.
