12
2.3.5 Adjusting the heat pump timer (RTC)
• From the home screen press and hold
for 3 seconds.
•
A new menu is displayed. Go to “
RTC”
(timer) by pressing
or
and then confirm by pressing
: the
date and time are displayed:
•
Press
and
to change the information and confirm by pressing
.
•
Press
to exit. Pressing
again takes you back to the main display.
Tip: to obtain a correct time setting
•
If the appliance is disconnected from the power supply for more than 72 hours, the timer must be reset
(date and time). This is important, particularly to view the alarms log, if required.
2.3.6 Adjusting the pool water temperature setpoint
The demand for pool water heating is specified by the user by entering a temperature setpoint. Reminder: the pool
water heating cycle will only operate if the temperature setpoint is greater than the measured water temperature.
•
The default temperature setpoint is set at 28°C.
• From the home screen press and hold
for 3 seconds.
•
A new menu is displayed. Select “
USER” via
or
and then confirm by pressing
: The temperature
setpoint SP01 displays:
•
When the SP01 setting is selected (highlighted black), press
to change the value. The SP01 setting will flash.
•
Press
and
to adjust the value and then confirm by pressing
.
•
Press
to exit. Pressing
again takes you back to the main display.
2.3.7 Locking/unlocking the keypad
•
Press and hold
and
at the same time for 3 seconds.
OR
EN
