background image

Cycling on and off with the pool filtration system, the Wahoo moves randomly around the pool,
vacuuming and cleaning the pool floor as it goes. The cleaner is not designed to climb the pool walls. 
As water flows through the cleaner, dirt and debris are pulled directly into the filtration system.

To maintain cleaner performance:

Thoroughly clean the skimmer basket, pump basket and filter regularly. 

Always disconnect the

cleaner before backwashing

. Run the filtration system for at least five minutes before re-connecting.

Always remove the cleaner from the pool before super chlorinating or adding pool chemicals. Wait at
least four hours before re-connecting the cleaner.

Never coil the hose. Straighten a coiled hose with warm water or by laying it in the sun for a day. 

A kinked or coiled hose will adversely effect the cleaner’s coverage of the pool.

When not in the pool, keep the disc flat to avoid warping.

Periodically inspect cleaner parts for wear.

Clearing the Diaphragm

A quick access system allows easy access 
to inspect and clear the diaphragm.

To remove:

1.

Turn handnut counter-clockwise to loosen 
the outer extension pipe. Remove the pipe.

2.. Turn the cleaner over. Grasping the diaphragm

flange, pull out the diaphragm and inner pipe.

3.

Pull off the diaphragm. 

Inspect it for debris or wear, and rinse it 
thoroughly with water. Replace if necessary.

To install:

1.

Verify that the retaining ring is on the diaphragm.

2.

Push diaphragm onto inner pipe. 

3.

Aligning the flange of the diaphragm with the slot in
the cleaner body, push the diaphragm assembly into
the cleaner until it is flush against the inlet plate.

4.

Reinstall outer extension pipe and secure handnut. 
Do not over tighten.

Storage and Winterizing

Never coil the hose. Always store the cleaner out of direct sunlight. When storing for the winter, drain all
water from the cleaner. Remove all connectors and adapters from the skimmer. Store disc flat, and hose
sections disconnected, drained and straight.  

Operation and Maintenance

6

Diaphragm

Inner Pipe

Retaining
Ring

Flange

Diaphragm

Содержание Wahoo









Отзывы: