Section 4. Maintenance
WARNING
To avoid electric shock and other hazards which
could result in permanent injury or death, disconnect
(unplug) the cleaner from the power source before
performing any cleaning and maintenance.
4.1 Cord Tangling
IMPORTANT
The power cable may become tangled if correct
procedure is not followed after each cleaning cycle.
Do not leave the cleaner unattended for prolonged
periods and follow the procedure below to avoid
excessive tangling.
After every cleaning cycle:
1.
Unplug power to the cleaner at the control unit.
2.
Remove the cleaner from the pool and untangle
all kinks and coils in the power cable starting at
the cleaner head (Figure 13).
3.
Plug power cord back into control unit and store
cleaner out of direct sunlight for next use.
Figure 13. Untangle the Power Cord
4.2 Replacing the Brushes
The cleaner is fitted with PVC brushes in front and rear.
There are ''wear'' indicators (Figure 14) on the brushes.
To maintain cleaner performance at its best you need to
replace the brushes as soon as one of the wear indicators
has been reached (even if the blade wear is not even).
Zodiac Pool Systems, Inc. recommends that you replace
the brushes every two (2) years.
Figure 14. Wear Indicators
1.
Separate the edges of the brush, undo the tabs,
and remove the worn brush.
2.
Position the new brush underneath the roller
with the spikes facing downwards. Refer to
Figure 15.
Figure 15. Position the New Brush on Roller
3.
Thread each tab into the slot provided and
gently feed it through until the heel comes out
at the other side of the slot. Refer to Figure 16.
4
Figure 16. Pull Tabs Through Each Slot
Page
9
ENGLISH
Zodiac
®
FX20 FX30 FX35 Robotic Pool Cleaner
|
Owner's Manual
