Zodiac pH Perfect, Руководство пользователя

Страница: 8 / 26

The linear distance between the sensor and the injection point should not be less than 60cm.
The injection point should be the last element on the intake before the pool.
The cable should not run in the same area as the power supply to large pumps or any electrical
cable, in order to prevent electrical interference.
The maximum pressure in the pipes should not exceed 1.5 bars.
To increase the life span of the peristaltic tube, pressure should not exceed 1 bar.
Installations having a Chlorinator, heater or any other treatment system should be situated after the
pH sensor and before the acid injection point.
Installing the Control Unit
Install the pH Perfect Controller on a rigid support (a vertical wall) in a place easily accessible to
the operator. Attach the wall bracket using the screws supplied and attach the pH Perfect.
Before doing any work inside the appliance make sure that the main switch is in position 0. By
completely unscrewing the two screws on the right-hand side of the appliance, the pH Perfect can
be opened sideways.
Connect the central cable including a plug (“power feed” label) to a permanent 230V AC mains
socket. Connect the right-hand side direct control cable to the pool pump (single-phase 230V AC).