4
1 Sodium dichloroisocyanurate dihydrate
A
B
C
A
B
C
Install the Nature
2
®
Spa
1 Drain and refill your spa. Balance the water per spa
manufacturer guidelines.
2 Install the Nature
2
Spa after water is balanced. Refer to
Assembly and Installation Diagrams below for instructions
regarding your particular model’s installation.
3 Superoxidize the spa water with an EPA registered source
of chlorine according to manufacturer’s instructions to burn off
contaminants and activate cartridge.
• Add 1.5 tablespoons of dichlor to spa per 250 gallons
(approx. 1000 liters).
• Note: 1.5 tablespoons is approximately 3/4 ounce or
24 grams.
• Do not enter the spa if the free available chlorine residual
is over 5 ppm.
Important:
Initial superoxidation with dichlor
1
is required to
burn off contaminants and activate cartridge.
4 Run spa according to recommendations supplied to you by
the manufacturer of your spa.
Assembly and Installation Diagrams
The Nature2 Spa comes in three (3) parts: the main body (A) and
two (2) support stems (B and C).
1 Connect the support stems together and press onto main
body to create a single device as shown.
Note: The Nature2 Spa is designed to fit most portable spas.
Zodiac Pool Systems, Inc. assumes no liabilities for the product
if installed in any way other than the methods described in this
manual.
