From the setup menu, select
DISPLAY LIGHT
. Press
MENU
. Using the arrow keys, select the desired
operating mode for the display backlight:
LIGHT OFF:
Turn off display backlight.
LIGHT ON:
Turn on display backlight.
2 MIN TIMEOUT:
Turn on display backlight, with
automatic turn-off after two (2) minutes since the last
key press.
5.6 Language Selection
From the setup menu, select
LANGUAGE
using the
arrow keys. Press
MENU
. Using the arrow keys, select
the desired language. Press
MENU
to save the selection.
5.7 Run Duration (Speeds 3 and 4 Only)
Speeds "3" and "4" may be programmed to run for a
specified duration after being manually started. This run
duration is programmable from 30 minutes to eight (8)
hours, in increments of 30 minutes. A setting of 0:00
disables the run duration feature, allowing the speed to
run indefinitely.
From the setup menu, select
RUN DURATION
. Press
MENU
. Using the arrow keys, select the speed to be
programmed. Press
MENU
. Set the desired run duration
for the speed using the arrow keys. Press
MENU
to
accept.
5.8 Password Protect
Entry into the
USER SETUP MENU
may be restricted
by the setting of a four-digit password.
NOTE: There is a 10-minute delay period from the
last key press to the password becoming active. This
allows additional, protected operations to be performed
temporarily after setting the password.
From the setup menu, select
PASSWORD PROTECT
and press the
MENU
key.
The menu will verify if the user wishes to set a
password. Using the arrow keys, select
YES
then press
the
MENU
key.
Using the arrow keys, select a value for each password
digit. Press the
MENU
key to set each digit.
When the last password digit is set, the password is
stored and the controller displays
*PASSWORD
ACCEPTED*
and returns to the
OFF
mode.
SELECT USER SETUP
PASSWORD PROTECT
Changing a Password
From the setup menu, select
SET PASSWORD
and
press the
MENU
key. The controller displays
CHANGE
PASSWORD?
Using the arrow keys, select
CHANGE
and press the
MENU
key.
The current password is displayed. Using the arrow
keys, select a value for each password digit. Press the
MENU
key to set each digit. When the last password
digit is set, the password is stored and the controller
displays
*PASSWORD ACCEPTED*
and returns to
the
OFF
mode.
CHANGE PASSWORD?
CHANGE
Clearing A Password
From the setup menu, select
SET PASSWORD
and
press the
MENU
key. The controller displays
CHANGE
PASSWORD?
Using the arrow keys, select
CLEAR
and press the
MENU
key. The password is cleared and
the controller returns to the
OFF
mode.
PAGE 17
JEP-R Variable-Speed Pump Controller
|
Installation Manual
ENGLISH
