USER MANUAL
USER MANUAL
A. BNC Video Inputs CH1-CH8
B. BNC Video Out 1-2
C. RCA Audio Inputs
D. Audio
E. LAN Port
F. USB 2.0 Mouse Port
G. VGA Output
H. RS485 Input
I. External Sensor Input
J. Alarm Input
K. DC 12V Connector
L. Power Switch
M. Cooling Fan Vent
Table 2-3: 9108UV Rear Panel Controls
2.3 – REMOTE CONTROL
Table 2-4: 9108UV Remote Control Functions table
3- INSTALLING YOUR DVR HARDWARE
This section refers exclusively to the connection of hardware to the DVR.
Forinformation regarding software configuration, please refer to the applicable
section of the manual.
1.
Remove chassis screws.
2.
Slide back DVR chassis cover.
3.
Insert data cable securely into hard drive.
4.
Insert power cable securely into hard drive.
Data
Cable
Power
Cable
Figure 3-5: Inside the DVR with hard drive installed
3.2 - CONNECTING YOUR CAMERAS
3.2.1 - INDOOR/OUTDOOR, DOME, AND BULLET CAMERAS
What you will need:
·
Camera
·
DVR
·
Video + Power Extension Cable
·
12V Power Adapter or Power Box
Important!
Do not use any other power sources other than those provided by
Zmodo
Your camera has a built-in cord that splits into one (1) BNC video connector and
one (1) RCA 12V DC power connector.
Step 1:
Connect the female BNC video
connector from the camera into the male
BNC video connector of the extension
cable. The male end attaches to the
female end clockwise and locks into
place.
Step 2:
Your 4-Channel DVR has four
video input ports, labeled CH1 to Ch4,
corresponding to the channel that is viewed
and configured in the DVR console. Select
the video input channel of your choice and
attach the BNC connector on the other end
of the extension cable to the video input
channel.
Figure 3-6: Video/power extension cable and camera's BNC female
video cable connected
Figure 3-7:
DVR rear panel with CH1 input, power adapter, and
VGA output connected.
3.1 - INSTALLING YOUR HARD DRIVE
If a hard drive was selected with the purchase of the DVR, the hard drive is
already installed. Although not recommended, a bare DVR can be purchased
without a hard drive, requiring one to be installed separately.
5.
Place hard drive upside down in bay and fasten with screws.
6.
Carefully replace cover.
7.
Reattach chassis screws.
Data
Cable
Power
Cable
Figure 3-6: SATA HDD cable connections
Important! There is only one way to correctly connect cables. If the connections
do not fit together properly, reverse the cables.
5
6
A
B
D
F
H
L
J
Q
R
C
E
I
G
K
O
M
N
P
Figure 2-4: Remote Control
A Keypad 1-8/Select Channel
B Keypad 9
C Toggle Multi-Channel Views
D Main Menu/Escape
E Keypad 0
F Move Up
G Move Left
H Move Right
I Select
J Move Down
K Audio/Search (Not Used)
L Mute (Not Used)
N Record
O Play/Video Search
P Pause/Unpause
Q Fast Forward
R Stop
Содержание H9108UV
Страница 1: ...H9108UV ...
