ZSPM4521
Evaluation Kit Manual
Kit Description
February 12, 2013
© 2013 Zentrum Mikroelektronik Dresden AG
— Rev. 1.00
All rights reserved. The material contained herein may not be reproduced, adapted, merged, translated, stored, or used without the
prior written consent of the copyright owner. The information furnished in this publication is
subject to changes without notice.
9 of 18
8
Connecting the FTDI Cable to ZSPM4521 Eval Board:
Connect the female connector of the FTDI USB/ I
2
C™ cable to J6 of ZSPM4521 Evaluation Board being careful to
use the orientation shown in Figure 8.1. The order of the leads in the cable from left to right is black, gray, and
then orange. Note that the last pin on the right on J6 has been removed to ensure that no accidental connections
can be made, which would damage the board.
Figure 8.1 Connecting the FTDI USB/ I
2
C™ Cable to J6
Ensure that cable is connected flush with
left side of J6 with black lead to the left.
Pin 1 on J4 has been
removed to avoid
connection errors.
