CANSwitch-AN2S2
High-Performance Dual-CAN to Ethernet Switch User Manual
©2021 Guangzhou ZLG Microelectronics Technology Corp.,Ltd.
36
User Manual
4.4.2 Configuring the CANSwitch-AN2S2 Device
Figure 4.30 shows the configuration in TCP CLIENT mode.
4.4.3 TCP&UDP Software Operation
Install the TCP&UDP test software, as shown in Figure 4.31.
Figure 4.31 TCP&UDP test software
Double-click the TCP&UDP software and click Create Server. If there are multiple
network cards and you need to specify the server IP address, enter the server working
port and click OK. See Figure 4.32.
Figure 4.30 Configuration in TCP Clarinet mode
Be
sure
to
submit
the
configuration
modifications
The default password is 88888
The IP address configuration should be
correct, and the PC and the device should be
on the same network segment
The baud rate should be 1000K, which should
be consistent with the CAN device connected
to the CAN0 port.
Select TCP Client method
Filtering is set, only the frame ID sent from the
CAN port to the Ethernet is filtered, and the
frame ID sent from the Ethernet to the CAN
port is not filtered.
Enter the server-side destination port number,
subnet mask, and IP address. If there is only
one server, set the start address and end
address to the same IP address.
