RGB FLOOD REMOTE CONTROLLER
Linking Instructions
LINKING & UNLINKING
05/21/2021
Specifications and actual product may vary.
Office (800) 679-9243 • Fax (888) 336-2165 • [email protected] • www.zled-lighting.com
Uninking Instructions
GROUPING OF SEVERAL LIGHTS
You can add an endless numbers of lights to a zone on the 4 channel remote by linking the lights to different zones. This way you are
completely flexible in creating different group combinations. Below you can see some grouping examples.
Remark:
1.
The user can re-program freely as needed. One remote can control countless lamps or controllers, but one lamp or controller can only be
controlled by four remotes (Max).
2.
Please check the battery installation and controller (totally discharge the power) when you program after switching off and switching on.
ATTENTION
1.
When using the remote, if the indicator lamp is blinking quickly, please change the battery.
2.
Please keep your finger off the touch ring when installing the batteries and use the remote ( 3 seconds later ) after the batteries are
installed. Please reinstall the batteries, if the touch ring is showing a low-sensitivity to touch.
3.
Don’t use in humid, high temperature, dust and high voltage environment. Use only in an indoor, dry and no static electricity environment.
4.
Please don’t use the remote controller on the wide-range metal or strong electromagnetic wave area, otherwise, it will badly affect the
controlling distance.
If the light does not blink slowly, the linking fails. Please switch off
the light again and follow the above steps again.
If the light does not blink quickly, the unlink failed. Please switch off
the light again and follow the above steps to unlink again
