ZKX Audio MT 1000, Руководство пользователя

Страница: 13 / 18

2 MT 400
- page 11 -
#11
For the BRIDGE mode put the switch on that position and connect only to each channel red knobs. As shown in figure 2 . DO NOT USE THE BLACK
KNOBS FOR THE BRIDGE MODE WHEN THE SWITCH IS ALREADY ON THIS MODE.
figure 2.
CHANNEL 1 CHANNEL 2
CONECTION MODE BRIDGE
FRONT PANEL DESCRIPTION
1
GAIN CONTROL
2
DIPS (Digital Intelligent Protection System)
3
OPERATION LED (OP)
4
POWER SWITCH
* Only reference for all power amplifiers MT, Mts and MTc series.
1 - GAIN CONTROL
These two knobs control the level of each channel of the amplifier. Gain increases will result when the knob is turned in hourly sense. This unit is
characterized by having gain controls.
2 - OPERATION OF THE DIPS SYSTEM
When the power unit is turned on, the DIPS protection system activates.The red LED (DIPS) located in the front, will flash three times for a second to
show the delay of the loudspeakers. Then the LED (OP) will switch on indicating that the unit is already in operation.
IMPORTANT: If after having lit up the LED (OP) or before this, the LED (DIPS) would remain on, it will indicate that the system presents some
malfunctioning in the lines of the acoustic system (short-circuit in the exit). If such is the case, do not worry your speakers will not be at risk.
If the anomaly were temporary the DIPS system will verify the exit in the fraction of a second and will be able to restore itself indicating correct
operation LED (OP).
If this did not happen check the lines of exit and repair the problem insulating wherever necessary. Take into account that the DIPS system will give
you up to five opportunities to correct the malfunctioning without turning it off. However, after the fifth signal of error detection, the LED (DIPS) will keep
flashing, blocking the unit until the drawback is solved. In order to re-start the system, turn off the unit to turn it on again just after few seconds.
3 - OPERATION LED (OP))
Each channel of the amplifier has a LED (OP) that indicates the system operation mode (Green, stereo mode/ Amber, bridge mode).
4 - POWER SWITCH
Though the series MT or MTs of amplifiers ZKX has a circuit with delayed ignition,a good practice is to reduce both gain controls before switching on
the amplifier.
The ignition procedure for an audio system must start from the instruments, followed by the blender and you must verify if all the system of operation is
normal before lighting up the amplifier.
USER`S MANUAL MT
,
MTs and MTc SERIES USER`S MANUAL MT
,
MTs and MTc SERIES