ZKX Audio MT 1000, Руководство пользователя

Страница: 12 / 18

#10
- page 10 -
FEATURES
Advanced powerful perfomance – third generation circuit design.
Output of high current.
Input limiter.
Selective stereo, bridge mono amp modes.
Independent gain controls.
Cooling reinforced by turbine.
Very rugged housing.
Fits a standard 19¨ rack”.
Automatic limitation system of rapid recovery by clipping.
DIPS: Digital Intelligent Protection System.
LINK: enable to link to other amplifiers.
INSTALLATION
MOUNTING
The power amplifier can be installed in a standard 19 inch equipment. It requires 3 units (5.25 inches) for the MT series of vertical rack space and
secures to the rack cabinet with four rack mount screws and cup washers. Inside every rack, it is best to mount the units one above the other, leaving
at least a unit of space between two amplifiers. This will provide for efficient airflow and support.
COOLING
Before mounting your amplifier, you should become familiar with its cooling requirements. The air flows from back to front, so it is important not to
block its frontal part. If the amplifier is rack – mounted, the open spaces on the front of the rack should be covered to prevent heated air being drawn
back into the back - to - front airflow. Airflow restrictions are the most common cause of inadequate cooling. They may result from improper mounting,
bundles of power cords, clogged dust filters and closed rack doors. Mount the amplifier to allow sufficient airflow out of the front outlets to ensure your
amplifier works properly.
CONNECTION
The connection of the series MT, MTs and MTc with their acoustic boxes, in the STEREO mode, must be accomplished in the following way: move the
switch on the rear part of your cabinet and put it on STEREO. Connect the positive (+) and the negative (-) wires coming out of each acoustic box to
each respective channel (channel I and channel II) as shown in figure 1.
figure 1.
CHANNEL 1 CHANNEL 2
*Selective level input 0dB u / 1,4V.
*Cooling with temperature control.
*Input switch LINK / OFF .
*Switch GROUND - LIFT .
* Only for MT 2000 and MT 2400s series.
0 MT 240
USER`S MANUAL MT
,
MTs and MTc SERIES USER`S MANUAL MT
,
MTs and MTc SERIES