ZKTeco TS2200 Series, Руководство пользователя

Страница: 3 / 10

3
Screw securing glue shall
be applied on the threads.
Note:
1. The space at the end of the arm shall not be greater than 80 mm (see figure 3-1).
2. Setting a warning line for card swiping (see figure 3-2). A warning line is suggested to prompt users to swipe cards in a distance,
which would greatly reduce the probability of equipment failure caused by improper operations.
Warning line for card swiping
Warning line for card swiping
Warning line for card swiping
Warning line
for card swiping
Assis
tant
fram
ewor
k
Figure 3-2
3.2 Cabling
There are inlets in the bottom plate for cabling, as shown in figure 3-3. Power supply and communication wire should go through the
inlet. Cable protection covers are suggested to use if it is surface mounted.
Warning : The tripod turnstile must be connected to Ground (earth), there is wiring interface in the power switch.
Figure 3-3
3.3 Installation
1.
Drilling holes
Drill holes based on the locations of the holes shown in figure 3-3.
2.
Fix the mounting plate to its original position
Placing the mounting plate properly and apply screw securing glue on the surface and the threads of the expansion bolts, install six
expansion bolts to secure the mounting plate, and use a horizontal ruler to test the levelness of the mounting plate. If the mounting
plate is not level, adjust it by the gaskets provided. Note that all the six expansion bolts must be installed properly, as shown in figure
3-4.
Figure 3-4
3.
Put the turnstile on the mounting plate and tighten the screws. Apply screw securing glue before use and put gaskets on the screws
to adjust the direction of the turnstile. If the tripod turnstile is not level, you can place gaskets to adjust, as shown in figure 3-5.
Figure 3-5
606.00mm
26
2.
00
m
m
Installation levelness
Installation levelness