According to the silkscreen on the shell of the TCP parking lot control panel, set the
controller's pull code. The entrance DIP1 is OFF, and the export DIP1 is ON.
1.
Align the device with the drilled holes. Then, insert the bolts accordingly and fix them with
a wrench. Finally, insert the washer and nut, tighten it with a wrench.
5.
3.4 Commissioning
After installing the parking ticket dispenser, please strictly follow the steps below to
commission the parking ticket dispenser controller.
Assembly parts inspection
Check whether the components in the parking ticket dispenser are intact and whether the fixing
screws are loose.
Check the electrical wiring before power-on
Check whether the entrance parking ticket dispenser, export parking ticket dispenser,
barriers, medium and long-distance card readers, computers and other related equipment are
connected correctly, and check whether all input and output terminals are loose. If the
connection is incorrect or loose, please re-wire to ensure that the connectors are in good
contact. After there is no problem, please use the expert network cable tester to test whether
the network cable is connected properly, and use a multimeter to check whether the power
input and output terminals of each device are short-circuited or open.
Check whether the system dial code setting is correct
Check whether the dialing code of the ID card reader is correct, DIP1 and DIP2 are both set
to ON.
2.
10
Nut
Washer
Bolt
①
②