SBT2000S Swing Barrier Turnstile
User Manual
P a g e
| 9
Copyright©2020 ZKTECO CO., LTD. All rights reserved.
2
Installation
Installation Notes
2.1
1.
It is recommended that the swing barrier turnstile be installed on a horizontal solid platform with
50 mm to 100 mm in height, the horizontal angle must not be greater than ±0.7°.
2.
It is recommended that the swing barrier turnstile should not be used in the corrosive
environment.
3.
Make sure the earth wire of the system is reliably connected to avoid personal injuries or other
accidents.
4.
After installation, check whether the connection is reliable at the connecting points of the earth
wire, at the connector assemblies and wiring points of the circuits, as well as at each movable part
of the swing barrier turnstile. Any loose nuts, screws and other fasteners should be tightened in
time to avoid any failures caused by long-time operations.
Installation Position
2.2
The installation position of the swing barrier turnstile depends on its size. If the swing barrier turnstile is
installed near a wall, a distance of 100 mm between the swing barrier turnstile and the wall needs to be
reserved for ease of installing the device. The SBT2000S swing barrier turnstile may form a single channel,
or two channels with a SBT2000S swing barrier turnstile, as shown in below figure.
Cables Installation and Fixation
2.3
For the outlets of the concealed cables, please refer to the below diagram showing the mounting holes.
The input voltage for this swing barrier turnstile is AC100V to120V/200V to 240V. The PVC conduits are
SBT2000S Single Channel and Dual Channel
