4
Figure 2-3A
Mark out the screw hole centers of the stand, and the edge of the chassis base on the ground
according to the sizes as shown on the figure 2-3A. Use a hammer drill to perforate M12 screw holes
and then install the screws. Place the swing barrier turnstile according to the sizes and positions as
shown in the figure before installation and fixation. Connect to the power and test. If the test is OK,
tighten the screws. It is recommended that a warning line be marked out on the ground after the
machine is installed, so as to prompt the pedestrian to stand behind the warning line when swiping
the card. As shown in Figure 2-3B.
Figure 2-3B
