ZKaccess inPulse, Быстрый старт

Страница: 18 / 33

18
inPulse & and ZKBioSecurity 3.0 Quick Start Guide
Device Opreation
Access Control Combination Settings
E.g. : Add an access control combination which requires 2 person’s verification from both Access Control
Group 1 (set in User Management) and Access Control Group 2.
Note:
A.
A single access control combination can consist of a maximum of 5 user groups (in order to open
door, verification of all 5 users is required).
B.
If the combination is set as shown in figure 3, a user from access control group 2 must obtain veri-
fication of 2 users from access control group 1 in order to open door.
C.
Set all group number to zero to reset access control combination.
Troubleshooting
1.
“Invalid time zone” is displayed after verification?
@ Contact Administrator to check if the user has the privilege to gain access within that time zone.
2.
Verification succeeds but the user cannot gain access?
@ Check whether the user privilege is set correctly.
@ Check whether the lock wiring is correct.
3.
The Tamper Alarm rings?
@ To cancel the triggered alarm mode, carefully check whether the device and back plate are se-
curely connected to each other, and reinstall the device properly if necessary.
1. In “Combined Verification” List, click the desired
combination to modify, and enter the interface (as
shown in figure 1).
2.
Click “+ / -“ to change the number, and click “Con-
firm” to save and back to “Combined Verification”
(as shown in figure 2).