Viewing reports
To view system status reports for the control panel and connected devices,
select Reports from the Main menu. Report information for this user level is
shown in the table below.
Table 7: Reports available to operator users
Report Description
Event log
Displays all alarm, fault, and condition events logged by the
control panel
Attention required
Displays all devices reporting a fault condition
Revision
Displays your control panel software revision, control panel
configuration revision, and system boards serial number data
Contact details
Displays contact information for your installation or
maintenance contractor (subject to installer configuration)
Zone status [1]
Displays the current status information for zones
Device status [1]
Displays the current status information for control panel
devices
Panel I/O status
Displays the current status information for the control panel
inputs and outputs
Output groups status [1]
Displays control panel output groups (sounders, fire routing,
fire protection, or program) that are currently active
Rules status
Displays control panel rules that are currently active
Firenet status
Displays the current status information for all control panels in
the fire network
[1] These reports are not available on repeater panels.
[2] A rule consists of one or more states (combined by Boolean operators) that are configured to
trigger specific system actions after a specific confirmation time. Rules are created by your
installation or maintenance contractor using the configuration utility.
Note:
To check the firmware version of your control panel, select Revision report
and then select Firmware version.
Changing your password
Use the Password setup menu to change your password.
To change your password:
1. Select Password setup from the Main menu, and then select Change
password.
2. Enter your current password.
3. Enter and then confirm your new password.
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
20
ZP2-F Series Fire Alarm Control Panel Operation Manual
