Chapter 1: Overview
22
ZP3 Fire Alarm Control Panel Installation Manual
Installation instructions
Figure 20 below illustrates the key installation elements for the printer. Detailed
steps for installation follow the figure.
Figure 20: Printer installation
To install the printer:
1. Ensure that the panel is powered down.
2. Remove the plastic knockout on the panel door.
3. Ensure that the orange and black cable is disconnected from the printer and
separate the printer from its bracket by removing the mounting screws.
4. Fit the printer flush with the panel door.
5. Install the mounting bracket as shown in the illustration. Line up the outer
holes on the mounting bracket with the threaded holes on the back of the
panel printer.
Panel door
Mounting
bracket
Ribbon cable
from printer to
display board
Printer
Mounting
screws
Printer PCB
Earth wire
Maestro communications
port PCB
Display board
