Zirkon zahn Face Hunter, Руководство оператора и по техническому обслуживанию

Страница: 11 / 40

11 11 CHAPTER
SAFETY AND RESIDUAL RISKS
MANUFACTURER
Zirkonzahn srl, Headquarters Italy – 39030 Gais – BZ, is the manufacturer of the Face Hunter and
is referred throughout the Operator’s and Maintenance Manual as Zirkonzahn.
GENERAL INFORMATION
This Operator’s and Maintenance Manual is an integral part of the Face Hunter and must be
kept in a place known to the operator and easily and immediately accessible at all times. Only
adequately trained personnel must handle the Face Hunter.
This Operator’s and Maintenance Manual covers all you need to know for safe use and
maintenance of the Face Hunter produced by Zirkonzahn srl. However, it is not intended to replace
a training course with regard to the scope of application.
6JG(CEG*WPVGTKUCPKORQTVCPVEQORQPGPVQHVJGFKIKVCNYQTMƀQYCPFKVUHWPEVKQPUCTGKFGCNN[
suited for working with the Zirkonzahn CAD/CAM system. The operation of the Face Hunter is
very intuitive. However, in order to fully exploit its potential, which mainly consists in the further
use of the generated data in the Zirkonzahn.Software, it is recommended to take part in the CAD/
%#//KNNKPI(CEG*WPVGTKPVTQFWEVQT[EQWTUG;QWECPſPFCNNKPHQTOCVKQPCDQWVVJGEWTTGPV
course programme and a list of Zirkonzahn Education partners in your vicinity on our homepage
www.zirkonzahn.com or by contacting us directly by telephone under +39 0474 066 650.
Operational capability and long-term value of the Face Hunter can only be guaranteed if service
and maintenance work prescribed in this Operator’s and Maintenance Manual is carried out.
This manual is subject to amendments at Zirkonzahn's sole discretion in the event of technical
further development.
The device complies with the applicable EU directives. The declaration of conformity is available
and will be sent to the user upon request.
SAFETY AND
RESIDUAL RISKS