Zip'r Traveler, Руководство пользователя

Страница: 14 / 18

Comfort Adjustments
Tiller Angle Adjustment
WARNING! Remove the key from the key switch before adjusting the tiller or the seat.
Never attempt to adjust the tiller or the seat while the mobility scooter is in motion.
WARNING! Prior to operating the scooter, push and pull on the tiller to ensure that the
angle adjustment mechanism is secure. Inspect the tiller adjustment knob and the angle
adjustment mechanism to ensure that they are fully engaged. If there is movement in the
tiller, check to make sure that the tiller adjustment knob is fully tightened.
NOTE: In order to fully lower the tiller for disassembly, you must first remove the seat. Remove
the seat by pulling it straight up and off of the mobility scooter. It is advised that you also remove
the battery back during disassembly.
Swivel Seat Adjustment
The swivel seat lever, located on the right side of the seat base, secures the seat into several
positions.
1. Pull up on the swivel seat lever to disengage the seat.
2. Rotate the seat to the desired position.
3. Release the lever to secure the seat into place.
Armrest Width Adjustment
The width of the armrest can be adjusted inward or outward.
1. Loosen the armrest adjustment knobs.
2. Slide the armrests in or out to the desired width.
3. Align the adjustment holes on the seat frame and armrest,
4. Tighten the armrest adjustment knobs.
NOTE: Lift armrests upward to aid in getting on and off your mobility scooter.
Seat Height Adjustment
The seat can be repositioned to different heights.
1. Use the attached ring to pull and remove the detent pin from the lower seat post.
2. Raise or lower the upper seat post to the desired seat height.
3. While holding the upper seat post at that height, align the adjustment holes of the upper
and lower seat posts. Fully insert the detent pin.
4. Replace the seat.
NOTE: To adjust the seat height you may need to fully remove the seat.