22
REAR SECTION
The onboard battery charger (not shown), the charger power cord receptacle, the
batteries (not shown), the main circuit breaker reset button, the ammeter, the
manual freewheel lever, the anti-tip wheels and the motor/transaxle assembly are
located on the rear section of your Zipr Breeze. See figure 7.
Ammeter
Main Circuit Breaker
Reset Button
Charger Power
Cord Receptacle
Motor/Transaxle
Freewheel
Assembly
Lever
Anti-Tip
Wheel
FIGURE 7. REAR SECTION
Charger Power Cord Receptacle
The charger power cord plugs into your Zipr Breeze battery charger by means of
the charger power cord receptacle.
Ammeter
During charging, the ammeter indicates the charging rate, or how hard the
charger is working to charge the Zipr Breeze batteries. See the “Batteries &
Charging” section of this manual.
Main Circuit Breaker (Reset Button)
When the voltage in your Zipr Breeze’s batteries becomes low or the scooter is
heavily strained because of excessive loads or steep inclines, the main circuit
breaker may trip to protect the motor and electronics from damage.
The main circuit breaker reset button pops out when the breaker trips.
When the breaker trips, the entire electrical system shuts down.
Allow a minute or two for your scooter’s electronics to “rest”.
Push the reset button to reset the main circuit breaker.
If the main circuit breaker trips frequently, you may need to charge your
batteries more often. You may also need to have your authorized Zipr
provider perform a load test on the Zipr Breeze batteries.
If the main circuit breaker trips repeatedly, see your authorized Zipr
provider for service or call (800) 760-9107.
YOUR ZIPR BREEZE CONTINUED