M. FLIP-UP ARMRESTS (ADJUSTABLE LOCKING, AND ADJUSTABLE LOCKING
1. Height Adjustment
a. Loosen the clamp hardware ( A) .
b. Move armrest clamps (B) up or down backrest posts to desired position.
c. Maker sure that the set screws (A) are aligned with the adjustment holes on the backcane.
d. Thread the set screws so that they are flush with the clamp body, and hold the adjustment securely.
NOTE – Do not overtighten the set screws. There is a chance that they could fall inside the backcane.
e. Tighten the clamp hardware (A) to secure the armrest in the new position.
2. Angle-Adjustment
a. Loosen adjustment bolt (C) and the Cam bolt (D).
b. Lift the armrest to the desired position.
c. Tighten Cam bolt (D) to 120 in-lbs.
d. Tighten the angle adjustment bolt (C) to 45 in-lbs.
3. Length-Adjustment (optional)
a. Remove foam grip or armpad (E) from armrest.
b. Loosen the nut and screw (F) in the adjustable flip-up tube.
c. Reposition the armpad at the desired length.
d. Re-tighten the screw and nut (F).
e. Re-attach foam grip or armpad back in place.
N. FOOTREST SYSTEM
The footrest position is key to keeping the body in the proper alignment, and providing a stable support for
your legs and torso. Make sure that your Sunrise dealer has correctly adjusted your footrests and/or legrests
with the advice of a healthcare professional. The original setup should not be changed without first checking
with that advisor. Legrests and footrests should be swung out of the way, or removed for transfers. .
NOTE – Footplate must have at least 2inches of clearance between the footplate and the ground to prevent
hitting obstacles and risking a fall or tip-over.
1. Footrest/Footplate positioning using the rotational clamp
a. Loosen the two rotational/Angle clamp screws (G)
b. Rotate the footrest/ footplate until the desired position and angle is achieved.
c. Tighten the Clamp hardware to proper torque (DO NOT EXCEED a 120 in-lb Max torque).
2. Footrest positioning using footplate spacers
a. Remove footplate spacers (Show)
b. Slide footplate to desired depth position.
c. Replace footplate spacers
3. Height range adjustment (Direct Mount Footrest)
a. Adjust the footplate mounting position by removing the button head screw from the adjustment hole
(L) and moving the assembly to the desired position.
b. Tighten hardware to proper torque (120 in-lb Max)
4. Height range adjustment (Extension Mount Footrest)
a. Loosen set screw (H)
b. Slide footrest extension tube up or down inside frame tube to desired height..
c. Tighten set screw to proper torque (120 in-lb)
49
48
47
50
WITH ADJUSTABLE LENGTH)
46
IX. DEALER SERVICE AND ADJUSTMENT
ZIPPIE X’CAPE
24
48
49
4
7
H
50
M
G
46
C
D
B
A
E
F
A
J
I
51
51
5.
Aluminum Angle Adjustable Footplate
a. Loosen bolts (I).
b. Adjust footplate (J) to desired angular position.
c. Re-tighten hardware (I).
MK-100090 Rev. C
