OPERATING
Z.I.P.P.E.R Maschinen Austria
www.Zipper-maschinen.at
Seite 34
HOLZSPALTER / LOG SPLITTER ZI-HS8PT / ZI-HS10T / ZI-HS12T
A: Locking screw
B: Ram travel adjusting rod
After completion of work, leave the riving knife and arm in the upper position drive (park posi-
tion). Then turn off the engine by pressing the on-off switch to "O" and disconnect the ma-
chine from the mains.
Let the machine cool down. Thereafter the machine should be cleaned and lubricated if neces-
sary. The splitter may only be vertically stored in a dry and clean place. Make sure that the
cap of the oil tank tightly closed and no oil leakage during storage.
14.2.1
Stroke height gap wedge ZI-HS8PT / ZI-HS10T / ZI-HS12T
For shorter pieces of wood, you can improve performance by shortening the gap diameter re-
trace.
To adjust the riving knife, perform the following steps:
Raise the trunk on the splitting table and run the riving knife to the desired position. The top
position of the riving knife should then be about 3-5cm above the piece of wood.
Let go of one control handle, so the splitting blade will stay in that position and turn on the
device.
Pull out the mains plug.
Let go of the second control handle.
Shorten the return on the attached adjusting rod (B), by fixing the locking screw (A) at the
required height.
Let go of a lever or turn the log splitter from.
Let go of both lever or turn the engine back on.
Check the new positions.
