OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
30
ZI-KTS40V-AKKU
Place saw chain around the saw rail starting
on the upper part of the rail. Slide the chain
in the slot around the saw rail.
When attaching the chain, ensure that it is
in the correct running direction.
Place elongated hole of the saw rail on the
stud bolt and the guide bolt on the chain saw.
Place the saw chain around the chain wheel.
Tighten the chain tensioning wheel
anticlockwise to tension the chain.
The saw chain must not sag, but it should be
possible to pull it 2-4 mm off the saw rail in the
middle of the saw rail.
Turn the saw chain by hand to check that it
runs perfectly. It must slide freely in the rail.
Attach the chain guard. Tighten the
handwheel to attach the rail and the cover.
NOTE:
Check and re-adjust the tension of a new chain after working for a few minutes.
13.3
Adjustments before using
Chain oil:
Check the amount of oil on the oil level indicator.
ATTENTION:
Fill the oil tank only with an environmentally
compatible quality chain and bar lubricant.
Do not use waste oil. Renewed contact with waste oil
can cause skin cancer. Waste oil is environmentally
harmful. Waste oil does not have the necessary
lubricating properties and is unsuitable for chain
lubrication.
An oil other than the one recommended may damage
the rail, the chain and the lubricating system.
Ensure that dirt does not get into the oil tank.
Avoid spilling oil. Always wipe up any spilled oil.
Topping up:
Unscrew the oil tank cap (
a
).
Carefully pour in the chain lubricating oil until it reaches the upper mark on the oil level indicator
(
b
).
Tighten the oil tank cap (
a
) by hand
