ZIPPER MASCHINEN ZI-HET40V-AKKU, Руководство пользователя

Страница: 30 / 41

OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at  30
ZI-HET40V-AKKU
Battery state of charge:
 Press the button on the battery to check the state
of charge at the state of charge indicator LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must be
recharged. If none of the LEDs light up after the
button is pressed, the battery is faulty and must be
replaced.
W O R K I N S T R U C T I O N S
 Check that all parts are firmly attached and obviously undamaged.
 Check that there are no leaks.
 Never work on unstable ground!
 Never work while standing on a ladder!
 Do not bend too far forwards when working!
 Use the power tool only when the weather conditions and terrain are favourable!
 Stand with both legs firmly on the ground.
 Beware of obstructions in the working area.
 When working, always hold the power tool with both hands!
After use:
Always switch the motor off before you put the power tool down! When the On/Off switch is
released, the saw chain continue running briefly.
 Stop the motor.
 Wait until all rotating parts have come to a standstill.
 Remove the battery.
 Place sheath on cutting mechanism.
 Leave power tool to cool down.
13.4 Basic working technique
 Look over the working area and remove any obstructions.
 Before starting work, check the safety of the power tool.
 Pick up the power tool in both hands.
 Switch the machine on before starting the cut.
 Apply a uniform pressure to the machine, however not
excessive force.
 If possible, place the unit's tree claw on the branch which
is to be sawn.
 Operate the saw at a maximum angle of 60°. Never cut a
branch directly about the head!!
 Start at the bottom of the trunk and work upwards.
 For an accurate cut thick branches should be sawn in 2
steps:
o
Saw upwards into the branch 1/3 of the branch
diameter (1.).
o
A little further up the branch saw through the branch
from top to bottom (2.).