MAINTENANCE
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
25
ZI-RPE160C
14.1.3
Checking oil level of exciter:
1. Put the compactor horizontally
2. Open the oil-filler neck
3. Oil level must reach the beginning of screw thread of the filler neck
4. If necessary fill in engine oil SAE 15W40 (use the hopper).
5. Close the oil-filler neck
Change the exciter oil every 300 working hours
1. Open the filler bore.
2. Cant the compactor as long as the complete oil has leaked. Fill in
the oil in a suitable container.
3. Put the compactor horizontal.
4. Fill in SAE 15W40 (ca.500ml) through filler bore SAE 15W40 respectively
5. Close the filler bore. ATTENTION! Do not fill in too much oil! Otherwise it can reduce the
performance and/or cause damages.
ATTENTION! Do not clean the exciter with a high pressure washer etc. otherwise water can
infiltrate the system.
14.1.4
Adjusting the V-belt
The V-belt connects the engine and the exciter. Especially with new
machines or even after the change of the v-belt this itself is getting wider
and loses purchase. If the V-belt yields more than 10-15mm on thumb
pressure, it is necessary to adjust the V-belt again.
1. Switch off the machine and take off the cover of the belt.
2. Loosen the screw of tensioner pulley, move the tensioner pulley forward to
the V-Belt until V-belt yields is less 10-15mm.
3. Fasten the screw of tensioner pulley.
4. Fix the cover of the V-belt again.
14.1.5
Carburettor
N O T I C E
Carburetor settings must be performed only by trained personnel!
14.1.6
Refuel
Each normal petrol (unleaded petrol) with octane index (ROZ) of 95 can be used. Never use a mix of
oil and petrol or dirty petrol. Avoid infiltration of the gasoline tank by water, dust or dirt.
N O T I C E
It is not recommended to use alternative for gasoline, because this can cause damage of parts
of the gasoline system.
14.1.7
Cleaning
Clean the machine and the working attachment from dirt.
Clean the machine housing with a wet cloth and a mild cleaning solution.
Put on all coatless flats a thin coat of oil.
N O T I C E
The usage of solvents, aggressive chemicals or scouring agents damages the machine
housing.
Tensioner pulley
