Zipp Manufacturing Bullitt Thunderboat, Инструкция по сборке

Страница: 34 / 55

R I V E T T / R O C K E T T
32
Bottom of hull taped around stuffing tube.
.
Stuffing tube epoxied in place.
View of radio box cutout.
Try to be neat, and put some on the
engine side of bulkhead 3.
Don’t move anything for at least two
hours.
Sand the hull bottom where the radio
box will go. This will be between
bulkheads 3 and 4, on the right side.
We recommend cutting the corner off of
the radio box for stuffing tube clearance.
This will allow the radio box to be
mounted closer to the center, making
the job of taping the lid in place much
easier.
Measure about 1 inch up, and about 3
inches back and cut the left front corner
off the radio box.
Sand this flat and glue the piece of
included 1/16 ply over the hole and sand
flush.
Seal this with finishing resin.
When cured, put a second coat of resin
on the radio box.
You don’t need to seal the bottom of the
radio box.
Use any leftover resin to seal the deck
bottoms if they don’t have 2 coats on
them.
You can also seal the top and bottom of
the cowl deck as well.
Using 30 minute epoxy, glue the radio