ADDING NEW DEVICES Z-WAVE OR ZIGBEE
Before adding new device, it is recommended to bring device closer to Zipabox, so
that no obstacle can interfere with operating range of device. Recommended distance
between sensors and Zipabox is less than one meter. Read device instructions
regarding inclusion/join mode. Device in inclusion/join mode is awake and ready
for joining in to Zipato network. Always reset device before adding it to the network.
Reset deletes any information about prior controller that was stored in device. At the
end of joining or removing session it is recommended to refresh Zipato Control Center
or wait until number of device is not increased by one to make sure that device is
visible in Total device list.
01 |
On Zipato dashboard, click “Add device” button in General widget and follow
wizard instructions. For Zwave devices, it is recommended that you reset your
device before adding it to the Zipato network.
02 |
After you successfully add the device in to your Zipato network go to “Total
devices” in General widget and set your device’s room name and type. This will help
you to control your device easier.
REMOVING DEVICES
To remove device go to Zipato Control Center and click on “Remove device” and
follow wizard instructions.
ADDING DEVICES
21
ZIPABOX
QUICK INSTALLATION GUIDE
20
ZIPABOX
QUICK INSTALLATION GUIDE
www.zipato.com
www.zipato.com
