10
807042 v1.00 03.21 HydroTap G5 UltraCare Install Instruct
Step 3 – Tap installation
Installation instructions
Cut a hole to suit your tap (35mm)
in the sink or benchtop using a
sheet metal hole punch or hole saw
(not supplied).
3.2
Push spacer on to the base of the
tap, with a light smear of silicone
sealant on the underside of the
spacer to ensure a watertight fit.
3.3
Position the tap so that water from
the spout will fall into a sink/tray
fitted with a drain
3.1
Pass the hoses down through the
hole and locate the tap in place.
3.4
From below the benchtop, push
the washer over the hoses and
threaded rod, then push the spider
clamp onto the threaded rod.
Check the tap is in the correct position,
then secure the fastening nut.
3.5
Tap
Washer
Benchtop
Nut
Spider clamp
Spacer
For more detail, refer to installation instructions supplied with the tap.
The tap tube length permits installation of a tap
height extension (not included).
For good fall of the water hoses, the tap tubes may
be shortened using a PVC
cutter (conduit cutter).
Ensure the cut edges are
not sharp, before fitting
the hose.
3.6
