05
Installation instructions & user manual
T210008 v3.00 May 2019 - Tudor
Technical support
Tel: 0345 6 005 005 email: [email protected] www.zipwater.co.uk
SAFETY INFORMATION
CAUTIONS
• The water vessel is intended for an open outlet and should never
be subject to greater than atmospheric pressure.
• The inlet control valve should not be subject to pressure
exceeding 0.35 MPa (3.5bar).
• The appliance must only be used when correctly installed and in
perfect working order.
• The appliance must be installed in a frost-free room and must
never be exposed to frost.
• The appliance must be completely filled with water before the
electrical supply is switched on.
• THE HOT WATER SHOULD BE DELIVERED FROM THE OPEN
OUTLET SPOUT SUPPLIED OR A ZIP APPROVED OPEN OUTLET
TAP FITTING THAT REMAINS PERMANENTLY OPEN TO ALLOW
FOR EXPANSION THAT OCCURS DURING THE HEATING CYCLE.
UNDER NO CIRCUMSTANCES SHOULD THE SPOUT OR OUTLET
BE CONNECTED TO A TAP WHICH IS CAPABLE OF BEING CLOSED.
• The Zip Tudor models are intended for connection to a mains
wholesome supply only. In any other case please contact Zip on
0345 6 005 005 for advice.
• Zip Water UK cannot be held liable for any damages caused by
failure to observe these instructions.
• It is recommended that an HE45004 Water Block is fitted in the
water supply line to minimise the potential damage in the event
of any leakage.
!
!
