13
Installation instructions & user manual
T210008 v3.00 May 2019 - Tudor
Technical support
Tel: 0345 6 005 005 email: [email protected] www.zipwater.co.uk
Installation
•
The inlet control valve supplied
incorporates compression fittings
suitable for fitting between 15mm
copper piping (water supply) and
the inlet connection (coloured
blue) situated on the water heater.
•
Fit the control valve to the cold
water supply ensuring that the
water will flow in the direction of
the arrow indicated on the side of
the control valve (Fig.2).
•
Do not over tighten the
compression joints but ensure that
they are leak free.
WATER
SUPPLY
Fig. 2
•
Connect the hose from (A) on the tap body
to the mains cold water supply.
•
Connect the hose from (B) on the tap body
to the cold water supply to the heater.
•
Connect the hose from (C) on the tap body
to the hot water output on the heater.
•
Fill the heater tank before turning the
power on.
•
Turn on the water supply and check for
leaks.
•
Open both hot & cold taps until water freely
flows from the tap spout.
•
Turn on the heater and allow it to heat up.
Note
When installing under-basin models it is
recommended that fibre washers are used on both inlet and outlet connections to
ensure a watertight seal.
Fig.3
Over-basin Installation
Under-basin Installation
Cold isolation valve
(not supplied)
A
B
C
Mains in
Cold input
Hot output
