Page 10 of 16
Zip Hydro Tap Installation and Operating Instructions - 81759 - February 2013 v2.01
Setting the Energy Saver Timer
(products with this feature only)
Normal Operation
Set Time
To change time, press either Mode or Mode button until Set Time is on
the display screen. Press
>
Adjust button to increase time or
>
Adjust button
to decrease time. Time increases or decrease in increments of one minute.
Hold the Adjust buttons down for rapid increases or decreases.
The time will be displayed in 24Hr mode.
Set Day
Press either Mode
>
or Mode
>
button until Set Day is displayed.
Press
>
Adjust or
>
Adjust to select day.
Filter Life ( factory set at 6000 Ltrs )
Press either Mode
>
or Mode
>
button until Filter Life is displayed.
Press
>
Adjust button to increase Filter Life or
>
Adjust button to decrease
Filter Life.
Filter Life increases in 1000 Ltr increments to a maximum of 10000 Ltrs.
Reset Litres Filtered
This function is to reset the Filter Change display after a filter has reached the
end of its life (refer to “Replace Filter Instructions” section of this document).
Press either Mode
>
or Mode
>
button until “Litres Filtered” is displayed.
Press
>
Adjust once and “Reset Counter” will be displayed, press
>
Adjust
button once and “Are You Sure” will be displayed.
Press
>
Adjust once and “Litres Filtered” will be reset to 0.
Activating On / Off Mode
Press the Mode
>
or Mode
>
button until “Monday On” is displayed. To set
the time for the unit to turn on press
>
Adjust button until required time is
reached.
To set the time for the unit to turn Off press Mode
>
button once and
“Monday Off” will be displayed. Now press
>
Adjust until required time is
reached.
If each individual day is to have an “On / Off” time, these steps need to be
repeated for each day and for each On / Off time.
Water Dispensing Mode
This function allows the user to alter the preset time the water may be
dispensed. This can go from 5 secs to 15 secs. (Factory set 15 secs)
To set, scroll through the menu to “Dispense Time”, press adjust
>
or
>
to
the desired time frame.
Note: The Hydrotap may be temporarily activated during the On / Off Mode. By
operating the levers, the unit will go into normal operation and then remain in
an “ON” cycle, until the next “OFF” cycle.
Mode Plus Button
Mode Minus Button
Plus Adjust Button
Minus Adjust Button
>
>
