Zip HydroTap 30009UK, Инструкция по установке и эксплуатации

Страница: 21 / 24

Hydro Tap Installation and Operating Instructions - 89026UK - June 2009 Page 21 of 24
The Zip HydroTap notifies when filter replacement is due. The default setting
is 6000 Ltrs, but this can be set in increments of 1000Ltr from 1000Ltr to
10000Ltrs. When a filter change is due, the Change Filter light will flash white
once a minute and remain so until reset. A filter status light is located between
the Red and Blue Lights on the tap head assembly.
Depending on local water quality conditions and usage, the filter may require
changing anywhere from 1000 Ltrs to 10000 Ltrs. You may also need to
replace the filter if you notice unpleasant odours or tastes.
Some water may drip from the filter head (socket) during replacement. Keep a
bucket and towel handy to catch drips and mop up any spills.
To change the Filter:
1. Scroll through the screen menu to “Filter Flush Off” this isolates the water
supply.
2. Open the left door or on the compact model, remove the front cover by
unscrewing the two Phillips headed screws and lift off to expose the filter.
Unravel the Blue filter flush line and place the open end in the bucket.
3. Relieve system pressure via the filter flush stop cock, a quick open and
close will do.
4. Grasp filter cartridge and twist right to left one quarter turn until it stops.
5. Ease cartridge downwards to detach it from the filter head (socket).
6. Do not tilt the cartridge as dirty water may spill from it if tilted.
7. Unpack replacement cartridge and write today’s date where shown on the
label.
8. Avoid touching the filter “O” rings and filter opening as this may cause
bacterial contamination of the cartridge.
9. Align cartridge tabs with the slots on the under-side of the filter head.
10. Slide cartridge upward into head and rotate left to right until it stops.
11. Locate the filter flush hose situated behind the filter cartridge and run to a
container ready for flushing. Open the flush hose tap lever. On the control
panel press adjust
> , this will start the water flushing the cartridge. Allow
at least 7.5 Ltrs of water to run through to activate the filter and then press
adjust
> to stop the flow.
12. Isolate the filter flush stop cock and re-fit behind the filter cartridge.
13. Wipe up any spills and dispose of spent filter cartridge and packaging
thoughtfully.
14. Scroll through the menu to “Litres Filtered”, press adjust > to reset litre
counter. Press adjust > and it asks “are you sure”. Press adjust > again
to lock in the command.
15. Scroll through the menu to “Filter Used (Days)”, press adjust > to reset
the timer. Press adjust > and it asks “are you sure”. Press adjust > again
to lock in the command. After approx 10 seconds it will default to the
selected mode.
16. Close the door or refit the front cover to secure the appliance.
Replacing the Filter
(filtered models only)
Warning:
If the Zip HydroTap is switched off for a long period of time
(e.g. More than a weekend), run water through the chilled water outlet for
at least 5 minutes before consumption.
Domestic compact filter location
HydroTap filter location