Installation & Operating Instructions - 87078 - May 2012 v1.01
Page 7 of 12
Symptom
Possible Cause
Solution
No water flow.
Slow water recovery after
use.
Water not hot.
Water not chilled.
Alternating display
messages:
Water continues to boil
Water supply isolated.
Water supply not connected.
Power supply not connected.
Possible internal fault.
Filter may require replacement.
Unit is in Sleep Mode.
Unit has just come out of, or is in,
OFF cycle.
Possible internal fault.
Excessive use,
unit refilling or chilling down to
temperature.
Unit is in OFF cycle
Possible internal fault.
More than one fault identified
at the same time
High Altitude
Check water supply is on.
Check to ensure plumbing connection is made.
Check power plug is correctly fitted and switch is
turned on.
Contact local Zip Service Provider.
Check filter usage on LCD screen, if “fil-
ter change” is displayed follow instructions
on page 5.
Open Hot tap.
Contact local Zip Service Provider.
Contact local Zip Service Provider.
Record the number and type of faults
Contact local Zip Service Provider
Contact local Zip Service provider, ref. Altitude P3
Refer to the Hydrotap Workshop manual for set-
ting instructions
Trouble Shooting
In order to help preserve our environment we ask that you dispose of this product correctly. Please contact your local
city council for collection centre details.
End of life disposal
Warning:
Check Mains Supply
No Water
Check for blockages
Blocked Filter
Change Filter
Poor water quality
Change Filter
System reset.
Turn power OFF for 20sec then turn power ON
