Installation & Operating Instructions - 87078 - May 2012 v1.01
Page 5 of 12
Do not use strong, corrosive, spray or abrasive cleaners. Clean with a soft cloth or brush and mild soap and water.
Do not spray water over the appliance.
The appliance must never be located near, or cleaned with water jets.
Replacing t
he filter
The Zip Hydroboil Duo notifies when filter replacement is due. The default setting is 6000 Ltrs or 12 months, but this can
be set in increments of 1000Ltr from 1000Ltr to 10000Ltrs, or from 1-14 months in 30 day increments. Depending on
local water quality conditions and usage, the filter may require changing anywhere from 1000 Ltrs to 10000 Ltrs. You
may also need to replace the filter if you notice unpleasant odours or tastes.
Some water may drip from the filter head (socket) during replacement. Keep a bucket and towel handy to catch drips and
mop up any spills.
To change the Filter:
1. Scroll through the screen menu to “Filter Flush Off” this isolates the water supply.
2. Remove the filter cover on the left hand side of the unit and relieve the system pressure via the filter flush stop cock,
(located to the right of the filter) a quick open and close will do.
3. Grasp filter cartridge and twist right to left one quarter turn until it stops.
4. Ease cartridge downwards to detach it from the filter head (socket).
5. Do not tilt the cartridge as dirty water may spill from it if tilted.
6. Unpack replacement cartridge and write today’s date where shown on the label.
7. Avoid touching the filter “O” rings and filter opening as this may cause bacterial contamination of the cartridge.
8. Align cartridge tabs with the slots on the under-side of the filter head.
9. Slide cartridge upward into head and rotate left to right until it stops.
10. Locate the filter flush hose situated behind the filter cartridge and run to a container ready for flushing. Open the
flush hose tap lever. On the control panel press adjust > , this will start the water flushing the cartridge. Allow at
least 7.5 Ltrs of water to run through to activate the filter and then press adjust > to stop the flow.
11. Isolate the filter flush stop cock and re-fit behind the filter cartridge.
12. Wipe up any spills and dispose of spent filter cartridge and packaging thoughtfully.
13. (a) If using ‘Litres filtered’, scroll through the menu to “Litres Filtered”, press adjust > to reset litre counter. Then
it asks “are you sure”. Press adjust > again to lock in the command. After approx 10 seconds it will default to the
selected mode.
(b) If using ‘Filter life’, scroll through to “Filter Use (days)” press adjust ^ to reset timer counter.Then it asks “are you
sure”. Press adjust > again to lock in the command. After approx 10 seconds it will default to the selected mode.
14. Before finishing, it is important to scroll through the screen menu and exit from the “Filter Flush Off” mode, otherwise
the water supply will remain isolated.
Warning: If the Zip Hydroboil Duo is switched off for a long period of time (e.g. more than a weekend), run water
through the chilled water outlet for at least 5 minutes before consumption. The unit must be switched on for 30minutes
before being used.
Replacing the filter
Cleaning
Energy Saving
If Energy Saver Settings are required, the instructions for installing these are described on page 6 “Setting the Energy
Saver Timer”. Ensure that the clock matches your local time. If not refer to page 6 .
Installation continued
