803904 - Zip Assist - May 2016 - v1.00
Page 3 of 16
STEP 2 - WiFi Board placement
( HydroTap Built Post Feb 2016)
1. Mount the WiFi Board in the
horizontal position shown
2. Secure in place with the
two plastic pins supplied
WiFi Board placement
(HydroTap Built Pre Feb 2016)
1. Mount the WiFi Board
in the vertical position
shown.
2. Secure in place with
the two pozi drive
screws supplied (M2.5
x 6mm)
Plastic pins
Pozi drive screws
1. Turn the power ON
2. If necessary, upgrade the G4 LCD PCB to B02.4 or later,
for compatibility with the new WiFi PCB and Zip Assist.
3. Turn the power OFF and then ON again after this is
performed.
4. Attach the front cover
STEP 3 - Upgrade the Firmware
WiFi PCB
