803828 - Zip Filter Tap - Installation & Operating Instructions - Nov 2015 v1.02
Page 5 of 8
Filling the system
Turn ‘ON’ the water supply. Check the connections for leaks. Repair any found.
The filter cartridge and tubing are full of air until purged, and the filter cartridge requires activation when first installed.
Rotate and hold the operating lever on the Zip Filter Tap, allowing water to flow for a minimum of five minutes, until all of
the air has been purged from the system, and the cartridge has time to become fully activated.
Every time the filter cartridge is replaced, repeat this five minute procedure to flush and activate the new cartridge properly.
NOTE: When flushing the system, some black particles may be released into the water. This is normal. The water will
become clear after the first few litres.
Complete the installation and leave these instructions with client.
Service
All service work must only be carried out by a suitably qualified and experienced service person.
Before calling for service, check the water supply is turned ‘ON’ and OK.
Call Zip in Australia on 1800-638-633 for assistance, service, spare parts, or enquiries.
#
Installation Instructions
Operating
You can obtain filtered water within the rated capacity for as long as you rotate the
lever. (The lever may be rotated in both directions)
When the lever is in the upright position, the tap is OFF. The lever is spring loaded
and when released, will automatically return to the OFF position.
Cleaning
Never use strong, corrosive or abrasive cleaning materials on the Zip Filter Tap.
Wipe the outer surfaces clean with a sponge or a soft cloth using a mild soap and
water.
ROTATE
#
Operating Procedures
